How to switch the customer display to the Russian model
HANS
Original
2015-01-29 15:00:07
How to switch the customer display to the Russian model
customer display,pole display,2lines 20 characters display


We can be found in the customer display programming manual the following code, the general instruction using hexadecimal (Hex), in the following table, you can see that when n = 3C customer display can be set to Russian model, we use Directive "02053C".

Just put off significant changes to the Russian character mode the processor is not enough, we need to show up characters also switched to the Russian character mode, so we need to use the following piece of command "020 637"

After you have finished entering these two commands, customer display is switched to the mode of the Russian show