Set Printing Density for Mini Bluetooth Thermal Printer
Ella Zhang
OCOM Original
2014-12-24 17:22:24
For the bluetooth thermal printer in OCOM, OCPP-M05, OCPP-M03 and OCPP-M082. How to set it's printing density?
Power off the printer, then hold down the【FEED】button
and press the power button at the same time.Wait until the power indicator
&【ERROR】led
are both on.
Then 【ERROR】led goes out, after, 【ERROR】led
goes on again ,then loosen the【FEED】button, the density setting status will be
printed out.
(It has three levels setting for printing density, it is a circle
Low level - Middle
level - High
level - Low
level…, Please switch the density status by repeating operation presented
above.)