80mm wifi thermal printer setting
OCOM 80mm wifi thermal printer setting
wifi thermal printer,3inch thermal printer with auto cutter,China thermal printer factory
The setting parameters of 80 wifi thermal printer through the browser configured, the steps as below:
1, Plug and switch on the printer.
2,Find the wireless network and link it. Then find the file named “ HF-100B” and link it – after successful connection , go to next step.
3, Put the IP address ( 10.10.100.254 ) into the browser address bar, press enter we can see as below:
Enter “ admin” for the user name and default password is also “admin”.
Press ok and then Next:
Select “AP+STA mode” , and save.
Note: When the module is selected to STA mode (NIC), then re-start the module, you can not reuse the wireless configuration, SSID number can not be found.
4, Select “ STA Setting ” as below;
5, Then click “Scan”, it will appear selection as below:
Above are all your current wireless network, select one of your wireless device available to be used, then click “ OK ”.
6, Input the correct configuration within the dialog, as below:
STA setting is complete, click "save".
7, Select "Other Setting", setting as below:
After finish the setting, click “ Save”.
8,Restart the module, as below:
Module configuration is complete
9, Click computer “Start” “ Run”, Input word “CMD”，as below：
Input “ping 192.168.1.105 -t” as below
If details shows as below , means connection is Ok
Return to the driver -" properties " - " port "-" add port ", consistent with the add ports:
